Reviewer:
Somebody's failed high school project from colorado
The front bezel is too large to fit in a din dash opening. There are no known connectors that fit the rear cutouts. Only resistive or no-touch panels are offered, only accepting analog vga input and analog camera inputs.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Excellent case, excellent service
January 3, 2013
Reviewer:
richard slaughter from little Rock, AR United States
This is an excellent case - Using it to run an e-350 based computer with a 7" touch screen in the stock dash location of my Nissan. Had to modify it slightly for a car-specific fitment issue, but nothing major. The user that ranked this case 1* has some valid points, but when you're talking about putting a computer in a double din radio slot, it's going to be a tight fit with some customization and application-specific installation. If you go in with that expectation, this case is perfect for its intended purpose. Most importantly, MCS service has been consistently great to work with - HIGHLY recommended.
Was this review helpful to you?
0 of 1 people found the following review helpful:
this is the worst case ever
August 9, 2012
Reviewer:
Edwin from Maryland
Whoever designed this thing does not know anything. The instructions included are horrible. They do not show how to properly mount the IR receiver and the pictures don't even show the proper LCD frame (there is no USB port in the picture). It is near impossible to screw the "H" bracket in, the holes are directly behind the side edge of the case and there is no way to position a screw driver properly. Came with a bunch of screws but instructions don't clarify which screws go where. WTF.
Was this review helpful to you?
2 of 2 people found the following review helpful:
Great case!
February 14, 2012
Reviewer:
Aaron Widmer from Reading, PA United States
This case is great but the combination I used did not work well. If you plan on using the Intel D525MWv board, use the M2-ATX power supply as the M3-ATX DOES NOT WORK with this case/Motherboard combo! The pico chips that are on the M3-ATX power supply circuit board are too large and pushes out the side of the case and does not allow proper closure.
Chris has been very helpful to me to help resolve this issue!
Doesn't fit in din dash 
Excellent case, excellent service